Setup windows test client: Difference between revisions
Line 101: | Line 101: | ||
=Testing the new loop back device= | =Testing the new loop back device= | ||
{| width=" | {| width="70%" | ||
| valign="top" | | | valign="top" | | ||
From the Windows host try to open the URL<br> | From the Windows host try to open the URL<br> | ||
Line 113: | Line 113: | ||
|} | |} | ||
{| width=" | {| width="70%" | ||
| valign="top" | | | valign="top" | | ||
Goto myLVS and enable the Windows host and <br>disable the second host which does not exist yet<br> | Goto myLVS and enable the Windows host and <br>disable the second host which does not exist yet<br> |
Revision as of 18:51, 10 July 2015
Main
Step by step installation and documentation for Windows (lots of screnn shots).
|
Add a new loop back device
Right mouse click on your computer, |
|
Configure the new loop back device
Within Windows, goto the Network connections,
with Server 2012 you can run and type ncpa.ctl
Rename to loopback adapter to loopback, |
Enter the VIP (Virtual IP) = 192.168.2.220/24, |
Disable Automatic metric, |
Open an administrative console and enter:
netsh interface ipv4 set interface "lan" weakhostreceive=enabled netsh interface ipv4 set interface "loopback" weakhostreceive=enabled netsh interface ipv4 set interface "loopback" weakhostsend=enabled
See this for more information about those commands:
Testing the new loop back device
From the Windows host try to open the URL From an Network client try to open the URL |
Goto myLVS and enable the Windows host and |
Use an network client and open the |